We had quite a few logs ready for milling back in the fall and had even booked the sawyer. Then the first week of November the snow started. It has been a great winter for snow, not so much for milling logs. Most of the winter the logs were completely buried. So spring is here the snow is gone and Dad and I spent a good portion of the last two days cutting down trees and pulling them out of the bush.
Yesterday we took out a good sized ash tree, including one of the biggest logs that we have ever pulled. Today we dropped a dead butternut tree that fortunately was still solid. It yielded three good logs and one so-so log.
So at this point we have thirty-eight logs ready to be milled, including yellow birch (1), elm (1), ash (23), maple (3), cedar (5), butternut (3) and chestnut (2).
We're planning on dropping some beech, poplar, ironwood, hickory, ash, black cherry, basswood and cedar this spring. We only drop trees that are in decline or dead, we try and get them before rot sets in, but it's tricky, some species rot from within (like poplar) so by the time they look ready to take they're already hollow. Our best guess is that in addition to the logs we'll mill this spring we'll have another thirty to forty to mill in the fall.
The logs are rolled up onto scrap wood to keep them off the ground, but this is a temporary storage solution. Hopefully we haven't lost any logs to rot over the winter. We're planning long term storage for air drying the lumber. Even with access to a kiln the wood should be air dried for at least six months. Some of the wood (mostly the ash) we'll air dry for a couple of years so that we can use it for steam bending.